Reveal H Undercabinet

Cabinet and Bathroom Fittings

Sleek, modern 12V undercabinet lighting ideal for kitchens and wardrobes. Features innovative wave sensor for touch-free on/off and dimming, easy plug-and-play setup with 1.5 m leads, and a removable frame for simple surface mounting with a clean, concealed finish.

Where to buy Got a question?

Options

Dimmable

Specification

Input

12V

Temp

-20°C - 40°C

Lifetime

L80 54000h

CRI

SDCM

Class

IP Rating

IP20

IK Rating

IK05

Features

Sleek and modern undercabinet lighting range suitable for kitchen cabinets, wardrobes, and other residential cabinetry.
Low voltage (12V) system for safe and efficient operation.
Innovative wave sensor control allows touch-free on/off activation and dimming with a simple hand gesture.
Simple plug-and-play system, with each light featuring a 1.5m lead and plug for easy, direct connection to the driver.
Removable frame ensures easy installation, allowing for quick surface mounting and seamlessly clicking back into place to conceal screws for a clean, polished finish

Variants

Similar Products

Reveal L Undercabinet

Reveal P Undercabinet

Reveal T Undercabinet

Reveal R Undercabinet

FAQ

: Declarations of Conformity are available on request, please contact our Technical Department (compliance@anselluk.com)

)
: All electrical devices are tested to determine a level of resistance against the intrusion of solids and liquids.

Once tested, the product is given an IP rating, which stands for Ingress Protection. IP Rating uses a two-digit code where the first digit is a number value of between 0 & 6, for protection against ingress from a solid object, and the second digit is a number value of between 0 & 9, for resistance against ingress of moisture.

Ingress protection is important as it allows the safe use of lighting equipment within environments where it is possible dust particles and water may get into the fitting and having a suitable IP Rating will give customer confidence in purchasing lighting fittings which are suited to the application into which they are to be installed.

Read more in our blog article
: There are three classified zones and a further zone which is for installations classed as being outside of the other zones

Zone 0 is the area inside the bath or in the shower tray itself and if lighting is required, any fitting which is used must be LV, to a maximum of 12Volts and rated to at least IPX7.

Zone 1 is the area above the bath or shower tray up to a height of 2250mm from the bathroom floor with any fitting installed having a minimum IPX4 rating and if there is a likelihood of water jets being used for cleaning purposes, replace lighting to IPX5.

Zone 2 is the area extending to 600mm outside the perimeter of the bath and to a height of 2250mm from the bathroom floor with any fitting having a minimum IPX4 rating. It is good practice that the area around a wash basin, within a radius of 600mm of any tap is Zone 2 and if there is a likelihood of water jets being used for cleaning purposes, replace lighting to IPX5.

The areas deemed to be outside the Zones are anywhere within the bathroom which are located outside of Zone 0, Zone 1 & Zone 2, subject to their specific limits and where no water jet is likely to be used. Any fitting installed need not have any ingress protection, however if there is any likelihood of water jets ever being used replace the lighting to IPX5.

Full details can be found in the IEE Wiring Regulations.

Read more in our blog article.